| Standard Max Width |
up to 30' (9246 mm) depending on gauge and slat type |
| Standard Max Height |
up to 20' (6096 mm) depending on gauge and slat type |
| Insulation |
R-value of 7.71 (1.35 W/m2) for energy-efficiency.
U-value of .13 and sound transmision rating of 21. |
| Mounting |
Interior or exterior face of wall |
| Control panel |
Variable frequency drive controller with self-diagnostics (time delay self-close timer and non-resettable cycle counter included); LCD readout, enclosure NEMA 4X rated |
| Curtain |
Galvanized steel interlocking roll-formed slats, end locks attached to prevent lateral movement; Insulated flat profile (F-265i) for doors up to 30' wide - front and back slats 24 gauge.
Slat cavity shall be filled with CFC-free, foamed in-place, polyurethane insulation |
| Curtain finish |
Gray, tan or white PowderGuard® Max powder coat with hardening additive |
| Bottom bar |
Two PowderGuard® Premium powder coated black angles (min. thickness 3/16”) with 2-wire, self-monitoring, fail safe, electric sensing edge |
| Hood |
24 gauge galvanized steel primed, black painted; interior hood baffle included |
| Brackets |
Min. ¼” hot rolled primed, PowderGuard® Premium powder coated black steel |
| Guides |
Three structural steel angles PowderGuard® Premium powder coated black |
| Door roll |
Direct driven, springless roll with integrated shafts; self-aligning grease-able sealed bearings; door does not require counterbalance device |
| Stormtite™ perimeter seal system |
Exterior guide seal, interior hood baffle, bottom astragal |
| Safety devices |
Built-in brake mechanism provides additional peace-of-mind against uncontrolled curtain travel
Wireless monitored safety edge - all doors are equipped with a mandatory reversing or sensing edge to prevent entrapment.
Photoelectric safety sensors with guards - provide additional safety during door operation to help prevent injury and damage |
| Operation |
Direct drive, integrated gear motor/brake assembly (up to 24” per sec up speed / 12” per sec down speed); drive assembly and limit sensors are factory pre-assembled. Manual hand chain for power outage. Horsepower is appropriate to size and weight of door. 230V AC 3-phase motor |
| Actuator |
Single open/close/stop push button station incorporated into control panel |
| Wind load |
20 psf when optional wear strips are not specified |
